1
Currently browsing the page >> Rui Hong plastic >> Corporate News
Performance characteristics of aeration hoses
Release time:2016-03-30 Read:124次

1. Convenient assembly, installation flatness requirements are low, in the bottom of the gas pipe and aeration pipe combined, no additional pipeline equipment. The following are the same as the "

2. Can be curled packaging, small size, low transport costs. The following are the same as the "

3. Installation is simple, low installation costs, no leakage risk. The following are the same as the "

4. Hose in the aeration when the bulging, not aeration when the flattened, flattened, the variable microporous was closed, so stop the aeration time regardless of length, are not blocked. The following are the same as the "

5. Acid, alkali corrosion, no aging, no tear, long service life. The following are the same as the "

6. hose wall thickness of only 2mm, airway short and straight, low pressure loss, hose, the outer surface of high finish, do not attach biofilm. The following are the same as the "

7. High oxygen utilization, the price is lower than other aerators, high cost performance. The following are the same as the "

8. No special requirements for air supply, no air filtration equipment. The following are the same as the "

9. The surface of the hose has a stomatal surface, can be aeration, in the water, microbubbles, air bubbles rise slowly, uniform distribution, high oxygen utilization, stomatal elongated slits, width within a certain range variable. The following are the same as the "

10. Overcome the shortcomings of other aerator poor stability, no worries.



· On a piece of news:Industrial rubber hose introduction
· Next news:Hose characteristics
Sweep more information
COPYRIGHT © 2016 佛山市顺德区睿宏塑料制管厂 Copyright. Guangdong ICP preparation12049948Number / Technical support:SD668